Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterFast, Reliable Garage Door Installation Across Marietta
A new garage door installation in Marietta typically runs $700-$2,200 for the door and labor, with double-car and custom doors landing at the higher end of that range. Most homeowners we work with start by asking whether their 1980s steel door is worth repairing or if they should swap it now, before a spring snap or track failure forces the decision. If you’re in Marietta and researching this, you’re already ahead of the problem. Call (470) 243-8314 and we’ll give you a written price before any work starts.
We know Marietta’s housing stock. The brick ranches off Powder Springs Road, the split-levels along Sandy Plains, the colonials clustered around the Walton and Pope school corridors. These homes were built in waves between the 1970s and 1990s, which means their original garage systems are aging out on roughly the same schedule. That’s useful knowledge when you’re deciding whether to patch or replace.
Garage Door Installation in Marietta: Why Local Experience Matters
Marietta’s explosive suburban growth, driven by the Lockheed Martin Aeronautics plant and Cobb County’s 1970s-1990s corporate boom, produced dense waves of same-era subdivisions. What that means for your garage door: original torsion springs, steel doors, and pre-rolling-code openers are all hitting end-of-life simultaneously right now. Neighboring cities like Smyrna or Kennesaw, with more staggered growth timelines, don’t see this same concentration of full-system replacement work. We do, every week.
Here’s what that looks like in practice. We recently replaced a 1985 steel double door on a brick ranch off Powder Springs Road where the original torsion spring had snapped so violently it bent the end bearing plates. The homeowner had already replaced the opener once, but the real issue was the old door’s weight and spring cycles long past their 10,000-cycle rating. We installed a new Clopay steel door with high-cycle springs and corrected track alignment that had drifted over decades of red-clay slab movement. That’s the kind of job that separates replacing a part from fixing the system.
Garage Door Installation Services in Marietta
New Door Installation
A new door changes how the entire system operates: the opener strains less, the tracks stay square longer, and the seal actually sits flush against the slab. In Marietta, where summer humidity and spring pollen corrode hardware faster than drier climates, a fresh door with properly rated springs buys you years of low-maintenance operation. We quote the door, the labor, the spring rating, and the haul-away in one written price.
Single Car Door
Single-car garages are common on 1970s ranches in neighborhoods along Roswell Road and Whitlock Avenue. These doors are lighter and simpler, but the same failure modes apply: fatigue-cracked springs, rusted rollers, and tracks pulled out of square by slab heave. A single-car replacement in Marietta usually lands between $700 and $1,400, depending on whether you go with steel or a wood-look composite.
Double Car Door
Double-car doors carry more weight, which means the springs work harder and fail sooner if they’re undersized or past their cycle rating. In East Cobb’s 1990s-2000s subdivisions, where three-car garages are common, we often see double doors whose torsion springs were marginal from the start. When we install, we size the spring to the door’s full weight and set the track alignment to the slab, not to assumption. Expect $1,200-$2,200 for most double-door installations in Marietta.
Custom Garage Door
Older Marietta homes sometimes have non-standard openings: a 1970s side-load garage, a taller door on a split-level, a width that predates mass-produced standards. Custom doesn’t mean exotic. It means measuring the opening, building the door to those dimensions, and setting tracks that account for whatever the slab has done over 40 years. We handle custom sizing for steel and wood doors, including carriage-style replacements in East Cobb where the original wood-composite has warped from humidity and pollen delamination.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Install in Marietta
We install and service all major brands, including Clopay, Amarr, and Wayne Dalton doors, plus LiftMaster, Chamberlain, and Genie openers. More importantly, we stock high-cycle torsion springs, rollers, and track hardware sized for the steel doors most common across Marietta’s 1970s-1990s subdivisions. That means fewer trips back to the shop and a faster turnaround when you’re replacing a door that’s already failed.
Common Garage Door Installation Problems We See in Marietta Homes
- Original torsion springs snapping on cold January mornings. Years of Marietta humidity and spring pollen corrosion fatigue the steel. When a 1980s spring finally lets go, it’s often violent enough to bend end bearing plates. The fix is a new spring set matched to the door’s weight and cycle rating, not a like-for-like swap that inherits the same undersizing.
- Track alignment drifting from slab heave. Georgia’s red clay expands and contracts with rain and drought. Over decades, garage slabs in older Marietta subdivisions settle unevenly, pulling tracks off plumb. Rollers chew into the rails, panels rack, and the door starts binding. A new door installed on drifted tracks will fail early. We measure and correct alignment as part of every installation.
- Wood-composite carriage doors warping. East Cobb homes built in the 1990s and 2000s often have composite wood-look doors that absorb spring pollen and summer humidity. They swell, warp, and delaminate at the seams. Replacing weather seals doesn’t help because the door itself is no longer flat. The fix is a new steel or properly sealed composite door.
- Bottom seals frozen to the slab in winter. Marietta’s freezing rain and ice storms, not snow, are the real northwest-metro winter threat. Water seeps under the door, freezes to the slab, and rips the bottom seal when the opener tries to lift. A new door with a properly compressed bulb seal rated for freeze-thaw cycles prevents this.
Pricing for Garage Door Installation in Marietta, GA
We publish our ranges because Clause 1 of The Haven Standard requires a flat, written price before any work starts. “Call for a quote” is not how we operate. Here’s what Marietta homeowners can expect:
| Service | Marietta Price Range |
|---|---|
| New Door Installation | $700-$2,200 |
| Track Realignment | $120-$240 |
| Roller Replacement | $110-$220 |
| Panel Replacement | $250-$500 |
What moves the number: door size (single vs. double), material (steel is the most common for Marietta’s climate), spring rating (high-cycle springs cost more than standard), and whether we’re correcting track alignment at the same time. The price we quote is the price you pay. And if you already have a written estimate from another company, bring it in. We’ll give you a Free Second Opinion, no coupon required.
We Also Serve Cities Near Marietta
Our crews install garage doors throughout Cobb County and the northwest metro, including nearby Marietta neighborhoods and the surrounding communities of Smyrna, Kennesaw, Powder Springs, and Atlanta. If you’re on the edge of our service area, call (470) 243-8314 and we’ll confirm dispatch.
Serving Marietta, GA - Our Local Coverage Area
We’re based in the Marietta area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Garage Door Installation in Marietta
If the door is original and has never had a spring replacement, you’re on borrowed time. Original torsion springs on 1990s Marietta homes are typically rated for 10,000 cycles, which most hit years ago. Spring repair runs $180-$340, but that won’t address a door that’s rusted, racked, or sagging on drifted tracks. The smarter question is how many components are near failure. If it’s the spring only, repair makes sense. If the door itself is fatigued, a replacement in the $700-$2,200 range resets the whole system. We’ll photograph the failed parts and show you exactly what we found before quoting anything.
No. Door and opener are separate systems. We routinely pair a new Clopay or Wayne Dalton door with an existing LiftMaster or Chamberlain opener, as long as the opener is in good condition. If the opener is older than the door it’s lifting, we may recommend an opener replacement at $250-$550 to avoid straining a new door with worn gears or a failing logic board. Call (470) 243-8314 for a written assessment.
Usually, yes, but only if the gap isn’t caused by slab heave. Georgia’s red clay shifts, and an uneven slab creates gaps a new bottom seal can’t bridge. If the slab is the problem, we correct the track alignment or, in some cases, install a taller bottom seal profile before the door sits flush. The first step is measuring the slab and the door opening. We do that as part of every installation quote in Marietta, and we document it with photos.
In Marietta’s older subdivisions, the usual culprit is a torsion spring that lost tension or snapped, forcing the opener to lift the full door weight alone. That strains the motor and trips the opener’s internal overload. Pollen and humidity corrosion accelerate this. Before replacing the opener, check the spring. If it’s broken, spring replacement is $180-$340 and often restores the opener to normal operation. We’ll show you the spring before we quote anything.
We install custom-sized doors regularly. Many 1970s Marietta homes have garage openings that don’t match standard retail dimensions. We measure the rough opening, fabricate the door to size, and set tracks that accommodate whatever the slab has done over the decades. Custom doesn’t mean a huge upcharge: expect the same $700-$2,200 range depending on material and size, with the written quote covering everything before work starts.
Get a Written Price for Garage Door Installation in Marietta
If your garage door is original to your 1970s-1990s Marietta home, or if it’s binding, sagging, or leaving gaps at the slab, don’t wait for a spring snap to force a same-week decision. Call (470) 243-8314 or request service online. We’ll schedule a visit, measure the door and slab, and hand you a written price with a written scope before any work begins. That’s Clause 1 of The Haven Standard. And when we leave, you’ll have a documented photo record of what we found and what we did. Servo Garage Doors is independently owned and operated under The Haven Standard, with live phone coverage 24/7 and a 365-Day Done Right Promise on every job.
Written by Marcus Deller, Owner at Servo Garage Doors Douglasville, serving Marietta under The Haven Standard since 2015.
Garage Door Installation in Nearby Areas
